911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-284010.png)
18. Apply sealant to the sealing face of crankcase half 4-6.
19. With the help of a second person, place crankcase half 4-6 in position on crankcase half 1-3. Knock gently on crankcase half 4 -6 using a plastic
hammer. Pull timing chain out through chain space using a bent welding wire.
20. Position four new, coated M6 x 35 Torx screws -1- on flywheel side.
21. Position seven M6 x 35 Torx screws on belt pulley side -1-; then fit special tool centering mandrel 9645 for the intermediate shaft. Position
centering mandrel on the mounting point of the oil pump and turn the star knob clockwise until it is braced in the crankcase.
22. Position the remaining 13 M6 x 35 Torx screws on the crankcase. Tighten all screws in the cross bolt connection to the required torque in
accordance with the specified tightening sequence. Tightening torque 9.5 ft. lbs.
23. Carefully remove any remaining sealant on crankcase (particularly around the oil pan, intermediate-shaft bearing and crankshaft sealing rings).
24. Fit inner Torx screw with O-ring M9 x 140 for gear carrier -arrow- on crankcase half 4-6. Tightening torque 16 ft. lbs.
