911 Carrera (997) F6-3.6L (2006)
4. Insert piston/connecting rod unit into the retaining device 9597 in such a way that the twist lock in the second piston ring groove faces the
observer.
5. Carefully press out piston-pin circlip with a screwdriver; while doing so, place a cloth over the piston so that the circlip does not pop out.
6. Turn piston/connecting rod unit through 180° on the assembly device and press out piston pin with the plunger special tool assembly tool 9500.
7. Repeat steps for removing pistons/connecting rods on cylinders 2 and 3.
Assembling pistons/connecting rods, cylinder 1-3
Note: When removing pistons, the piston-pin circlip always remains in the piston, which is installed opposite the large assembly bore (no chamfer) for
the piston pin.
Note: The lug of the piston-pin circlip must always be touching the contact surface facing the oil piston shank.