911 Carrera (997) F6-3.6L (2006)
Driver/Vehicle Information Display: Service and Repair
Removing and Installing Multi-Function Control Unit
Removing And Installing Multi-function Control Unit
Technical values
Preliminary work
Preliminary work for multi-function remote control
Remove driver's airbag unit.
Removing multi-function control unit
INFORMATION:
-
The control unit is removed and, if necessary, replaced without reading, writing or coding the data with the PIWIS Tester. This procedure is not
required at present.
-
When removing the locking plate, take note of how many washers are used on each fastening screw.
-
During installation make sure that the washers are fitted in the same way as they were before removal.
1. Unscrew the four fastening screws -1- from the locking plate in the steering wheel and remove along with the locking plate.
2. Use a screwdriver to carefully lever the multi-function control unit out of the steering wheel.
3. Release electric plug connection -A- and disconnect it from the multi-function control unit.
Installing multi-function control unit
INFORMATION: The control unit is removed and, if necessary, replaced without reading, writing or coding the data with the PIWIS Tester. This