911 Carrera (997) F6-3.6L (2006)
/f6-3.6l/Page-898002.png)
INFORMATION:
-
After the seat-belt pretensioners have been triggered, they must be replaced. The fault can be read out using the PIWIS Tester P 9718. Observe
direction of travel.
-
If the seat-belt pretensioner has been triggered, cut through the belt strap before removing the seat-belt pretensioner. This ensures that the
defective automatic belt device is not installed again.
-
It is important to make sure that the negative terminal of the battery is disconnected.
1. Loosen seat belt and fitting.
1.1. Lever off cap -1- with a screwdriver -arrow-.
1.2. Unscrew fastening screw -2-. Remove washer -3-, seat belt mount -4- and spacer sleeve -5-.
2. Unscrew fastening screws -1- from the deflector -2-.
3. Remove belt -1- by pulling it towards the front.
