911 Carrera (997) F6-3.6L (2006)
2. Drive in sealing ring with pressure piece 96700 as far as the mounting face.
Subsequent work
Installing the torque converter
Note: Before installing the torque converter, check the hub for scoring. If damaged, the converter must be replaced.
1. Move torque converter up to stop on the transmission input shaft.
ATTENTION: The ATF pump can be damaged if the torque converter is incorrectly positioned during refitting.
^
Note the installation position of the torque converter.
^
Check installation position of torque converter.
2. Press torque converter by hand into the converter bell housing and turn until the cutout of the converter hub clicks into place in the driver of the
impeller. The converter must slip inwards until it makes a noise.
3. Fix torque converter with fixing pin 95951 (long) into installation position.
Fixing the torque converter
Subsequent work
1. Refit transmission.
2. After reinstalling the engine-transmission unit, the ATF level must be checked, and topped up as required.