911 Carrera (997) F6-3.6L (2006)
Installation position
Unscrewing grommet
1. After removing the wiper arm, unscrew the grommet -3- from the wiper arm drive to the right.
2. Unscrew the fastening screw -1- and the fastening nuts -2-.
Unscrewing the fastening screw and the fastening nuts
3. Take out wiper motor, release and unplug the electrical plug.
4. Take out the wiper motor.
Installing wiper motor for rear window washer
Installing the wiper motor for rear window wiper system
NOTE:
-
If a previously installed wiper motor is installed "again", the sealing ring/foam part -4- must be replaced due to water leakage.
-
The drive for the wiper arm must be uniformly spaced from the rear window.
Sealing ring/foam part
1. Position the wiper motor in the vehicle, while making sure that the drive for the wiper arm must be uniformly spaced from the rear window.