911 Carrera 4 Cabriolet (996) F6-3.4L (1999)
Accelerator Pedal: Service and Repair
Accelerator Pedal
Removing and Installing Accelerator Pedal
Removal
1. Pull off the centre air duct (A) in the driver's footwell.
2. Undo upper countersunk screw (M5 x 55) on the accelerator pedal and remove the accelerator pedal.
3. Disengage electrical plug connection on the bracket. To do this, turn the plug connection counterclockwise in the bracket and take it off.
Disconnect plug connection.
4. Undo two hexagon nuts (a/f 10 mm) on the pedal encoder.
5. Pull pedal encoder out of the stud, disengage cable from the cable disc and remove the pedal encoder in downward direction.
6. Press both locking tabs of the cable guide together by hand and simultaneously pull the cable out of the bracket