911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
/f6-3.6l/Page-306010.png)
Servo-tank
14. Fit drive belt. Pay attention to operating direction of used belts. Double-check that the position of the belt on the belt pulleys is correct.
WARNING: Danger of injury and damage to material through Pentosin.
-
Irritation and damage to skin.
-
Damage to hoses and wiring.
-
Wear protective gloves and goggles.
-
If the eyes or skin come into contact with the fluid, wash immediately with water.
-
Collect escaping Pentosin.
-
Use caps to protect the wiring against soiling and damage.
-
Immediately clean hoses and wiring thoroughly.
15. Check sealing rings on servo-tank and replace if necessary. Fit servo-tank by carefully inserting the tank into the opening of the servo pump and
fastening the bayonet lock in the clockwise direction. Fit fastening screw of servo-tank to intake distributor Tightening torque 7.5 ftlb.. Fill
servo-tank with Pentosin fluid and check oil level.
Subsequent work
Subsequent work for installing intake distributor
1. Install tuning pipe.
2. Install air cleaner housing.
3. Connect the battery.
Disassembling and Assembling Intake-Air Distributor
244637 Disassembling and Assembling Intake-Air Distributor
Disassembling intake-air distributor
Screw For Fuel Ring Pipe
1. Remove fuel ring pipe by unscrewing the four Torx screws (M6 x 12) and pull the fuel rail with fuel injectors from the seats.
2. Loosen spring band clamp -1- and pull off hose -2- on throttle body.
View Of Tank Ventilation Solenoid Valve
3. Remove cycle valve on intake distributor by unscrewing the tapping screw -arrow-.
