911 Carrera 4 Cabriolet (997) F6-3.6L (2006)
4. Adjust insertion tool in order to position the supporting sleeve of the sealing ring. Unscrew the hexagon-head bolt until the groove of the assembly
aid P 9699/ 2 is flush with the contact surface of the sleeve -arrow-.
ATTENTION: Damage to the sealing lip.
^
Leaks
^
The crankshaft flange and tools must be perfectly clean and free of grease.
^
The sealing ring must be fitted dry, i.e. no oil, grease or other lubricants can be used.
^
The crankcase bore must not be oiled.
^
The sealing ring can only be positioned on the assembly tool using the supporting sleeve.
^
The new crankshaft sealing ring (PTFE) is supplied on a supporting sleeve as a spare part.
^
Do not remove the sealing ring from the supporting sleeve.
5. Slide new crankshaft sealing ring -1- with supporting sleeve onto the assembly aid P 9699/ 2 by pushing only on the sleeve -2-. The collar of the
sleeve must point away from tool -inset-. Make sure sealing ring is dry.
6. Fit insertion tool 9699 between the two internal M8 pan-head screws, (hexagon socket a/f 8) on the crankshaft flange and fasten it. The crankshaft
flange"s dowel pin must sit in the bore of the device.