911 Carrera 4S (996) F6-3.6L (2004)
/f6-3.6l/Page-278003.png)
Dowel pin in cylinder head
2. Coat seal of the retainer plate with engine oil and slide it over the hydraulic valve
3. Fit both M6 pan-head screws (hexagon socket a/f 5) complete with holder -A- on the valve and tighten the screws.
Tightening torque 10 Nm (7.5 ftlb.)
4. Push the cable plug onto the hydraulic valve again. Make sure that the plug audibly engages.
5. Fit the side shield on the respective side of the engine. Put on and tighten the two M6 hexagon-head bolts for this purpose.
Tightening torque 10 Nm (7.5 ftlb.)
6. On cylinder side 4 - 6, refit the holder for the rear muffler and re-install the rear muffler.
