911 Carrera Cabriolet (997) F6-3.6L (2007)
/f6-3.6l/Page-877003.png)
NOTE: When sliding in the underbody trim panel, make sure the overlap is correct.
1. Insert cover for rear underbody -4-.
2. Tighten fastening screws -2-.
Tightening torque: 2 Nm (1.5 ftlb.)
3. Tighten fastening nuts -3-.
Tightening torque: 2.5 Nm (2.0 ftlb.)
Installing cover for rear underbody - front section
