porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Wheel Bearing > < Axle Shaft Assembly|Service and Repair|Page 2586
Page 5
background image

Rear anti-roll bar setting: 911 GT3/911 GT3 RS (997)/January 2007 = Position -3- (figure shows position -2-).

Any changes and additions will be incorporated/updated only in the main chapter entitled Adjustment values for suspension alignment, section on
Anti-roll bar setting.

6. Remove protection for drive shaft -arrow-.

7. Check parking brake adjustment and adjust if necessary.

Subsequent work

1. Fit wheel.
2. Tighten axle nut (vehicle on ground, also press the brake while doing this/two fitters required).

Checking wheel-alignment values

Check wheel alignment values and adjust if necessary.

Wheel Bearing > < Axle Shaft Assembly|Service and Repair|Page 2586