911 Carrera Cabriolet (997) F6-3.6L (2007)
Warning
Hot wheel bearing housing!
^
Danger of burns
--> Wear heat-resistant gloves!
2. Install bearing cover -2-. (arrow = cut-out for water drain)
Screw in and tighten screws -1-. --> Tightening torque: 37 Nm (27 ftlb.)
3. Press in wheel hub.
Position wheel bearing housing on wheel hub and press on wheel bearing inner ring using a tube VW 415 A.
Subsequent work
1. Install rear wheel bearing housing (wheel carrier).
2. Fit brake disc, parking-brake shoes, brake cover plate and speed sensor on wheel bearing housing (wheel carrier). Observe correct tightening
torques.