911 Carrera S Cabriolet (997) F6-3.8L (2007)
/f6-3.8l/Page-120012.png)
Installing compressor/evaporator line
INFORMATION:
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
1. Carefully insert the line into the engine-compartment disconnection point and secure with the fastening screw -3-. - Tightening torque: 14 Nm
(10.5 ftlb.)
2. Push the line on and secure it with the fastening screw -1-. - Tightening torque: 21 Nm (16 ftlb.)
Subsequent work
Subsequent work on compressor/evaporator line
Screw compressor to engine block.
Install drive belt.
Fill in refrigerant.
Removing and Installing Compressor-Condenser Line In Area of Engine
Removing And Installing Compressor-Condenser Line In Area Of Engine
Technical values
Preliminary work
Preliminary work on compressor-condenser line
