911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
4. Position the cover -1- and push it in until it snaps into place in the four clips.
5. Screw down cover with the fastening screw -3-.
6. If a new control unit has been installed, it must be programmed in the vehicle.
Subsequent work
Subsequent work - front control unit
Secure luggage compartment lining in the area around the front control module.
Coding control unit
Reading out and printing out values
WARNING:
Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery
charger with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
INFORMATION:
-
Follow the instructions on the Tester.
-
Later versions of the software may display slightly different text or require a slightly different procedure. The instructions you receive from the
tester itself take precedence over this description.
1. Connect the Porsche System Tester to the vehicle and start the System Tester. Switch on the ignition. >> Continue.
2. Select vehicle type.
3. From vehicle type, change to control units >>.
4. Select required control unit with the cursor keys and press >> key.
5. Select Control unit replacement with the cursor keys and press the >> key.
6. Select Read out values (codings) with the cursor keys and press the >> key.
7. The message Codes successfully read out appears on the screen of the Porsche System Tester. Press >>.
8. Switch off ignition and replace control unit.
9. Switch on ignition. After replacement of the control unit, the data previously read out (see Item 6) is reloaded under the menu Write in codes.
Press >>.
10. System Tester displays Coding write-in complete. Press the >> key.
11. Leave menu, read out all control units and erase fault memories.
12. Select front end on the control unit, carry out calibration menu.
13. Check headlight setting and adjust if necessary.
Coding the front end control unit
WARNING:
Sudden voltage interruption of the power supply to the control module.
-
Destruction of the control module.
-
During programming, it is essential to guarantee the power supply for the Porsche System tester. It is essential to connect a battery
charger with a current rating of at least 40 A to the vehicle battery.
-
Prior to disconnecting the control module, switch off the ignition and remove the ignition key.
INFORMATION: