911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
2. Position fastening nut -1- for oil line on the oil tank and screw on securely while countering at the same time.
3. Install intake-air distributor.
4. Install the two intake pipes at the sides.
4.1. Slide intake pipe onto the charger.
4.2. Screw in fastening screws -1- for the intake pipe. - Tightening torque: 10 Nm (7.5 ftlb.)
4.3. Clip in the cable clip on the intake pipe -2- and the vacuum line -3- on the intake pipe.
5. Install throttle valve.
6. Install air-conditioning compressor.
7. Install the generator.
8. Install drive belt.
9. Install engine.
10. Connect the battery and carry out work instructions after disconnecting the battery.
Removing and Installing Wire Harness For Front-End
Removing And Installing Wire Harness For Front-End
Technical values
Preliminary work
1. Disconnect battery.
2. Remove luggage compartment linings.
3. Remove front-end control unit.
4. Remove left and right headlight.
5. Remove front apron.
Removing wire harness for front-end