911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
5. Release old contacts of the potentiometer lines with the unlocking tool Press-out and unlocking tools for flat and round plug connections of every
size NR.155 and remove.
Installing potentiometer
1. Install and lock new contacts of the potentiometer lines. To do this, compare the assignment with the wiring diagram.
1.1. Install the new contacts of the potentiometer in the same position as follows:
1.2. Green wire (pin 1) to pin 9
1.3. Yellow wire (pin 2) to pin 4
1.4. Red wire (pin 3) to pin 8
1.5. Close the secondary lock of the plug connection with a small screwdriver again.
2. Winding insulating tape around wires
3. Tighten potentiometer with both fastening screws.
4. Route the electric plug connection and engage.
Subsequent work
Subsequent work on potentiometer
1. Fasten hydraulic cylinder and install rear left side-panel lining. Refer to Removing and installing convertible top.
2. Convertible top out of the service position, Refer to service position for convertible top.