911 Turbo Cabriolet AWD (997) F6-3.6L Turbo (2008)
Information
Information
The wheel bearings adopt the function of the former ABS pulse rings. They are fitted with a so-called multipole seal. This is a seal with a magnetized
layer, which generates the torque impulses for the ABS rpm sensors.
The multipole seal must not come into contact with highly magnetic parts. During installation, make sure that the magnetic side is facing the ABS
sensor. Use test card 147-2 for this.
Wheel bearing
Preliminary work
-
Remove front wheel bearing housing (wheel carrier).
Removing front wheel bearing
The following tools are required for removing the rear wheel bearing.
1. Take off brake cover plate on the wheel bearing housing.
2. Press out wheel hub.