911 Turbo S Cabriolet (996) F6-3.6L Turbo (2005)
35. Connect the vent hose. Tighten hose clamp -arrow-.
36. Position and tighten the three screws at the front intake pipe connector.
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
37. Position and tighten the upper screw -right arrow-.
Tightening torque of M6 screw = 10 Nm (7.5 ftlb.)
38. Tighten the M6 screw in the holder -3-.
Tightening torque of M6 screw = 10 Nm (7.5 ftlb.)
39. Tighten the hose -arrow- on the left pressure pipe. To do so, push the hose -arrow- on and tighten the screw-type hose clamp.
40. Install the overrun air valve module -Figure-.
41. Connect the connector of the overrun air valve module -arrow- and push on the two vacuum hoses -arrow-.