Boxster S (987) F6-3.2L (2005)
Steering Control Module: Service and Repair
916219 Removing And Installing Control Unit For Steering Wheel Electronics
Tools
Preliminary work
Preliminary work on control unit for steering wheel electronics
1. Remove driver's airbag unit.
2. Remove steering wheel.
3. Remove steering column trim.
4. Remove steering column switch.
Removing control unit for steering wheel electronics
NOTE:
-
The control unit for steering wheel electronics is bolted to the steering-column switch.
-
Before the ground strap of the battery is disconnected, the data in the control unit for steering wheel electronics must be read out using the Porsche
System Tester.
-
Ensure that the arrow -A- of the rotor is positioned between the markings -B- of the arrows -C- of the airbag contact unit and that the latch -D- is
engaged.
Position Of Markings
1. Remove contact unit.
1.1. Carefully lift up the three retaining tabs and remove airbag contact unit.
Removing Contact Unit
2. Unscrew fastening screws for steering wheel electronics control unit.
2.1. Unscrew the five fastening screws.
Unscrewing Fastening Screws
3. Push out the line holder.
3.1. Push line holder down and out of the steering-column switch.