Boxster S (987) F6-3.4L (2008)
Pressing out wheel bearing
Warning: Hot wheel bearing housing!
^
Danger of burns
--> Wear heat-resistant gloves!
6. Press out wheel bearing inner race.
Information: To press out the inner bearing race of the old wheel bearing, pull the inner bearing race several millimeters off the wheel hub using a
two-claw puller so that the separator can be put into place. To do this, use a two-claw puller together with a pressure piece VW 433, for example.
Pull inner bearing race several millimeters off the wheel hub using a two-claw puller.
Press out inner bearing race using a press-out mandrel P 297a together with the separating device ([diameter] = 12 - 115 mm) NR.111.
Pressing out bearing race
Installing rear wheel bearing
Installing
Before installation, clean the bore in the wheel bearing housing and remove edges with a polishing cloth.
The following tools are required for installing the rear wheel bearing.
1. Press in wheel bearing.