Boxster S (987) F6-3.4L (2008)
Installing ATF pan
Installing ATF pan
1. Clean sealing surfaces of ATF pan and transmission.
2. Clean magnet -4- and place it in the bead of the ATF pan. Ensure contact over full area.
ATF pan
3. Fit ATF pan -2- with new seal -3- and screw in screws -1-.
4. Tighten screws to specified tightening torque --> Tightening sequence:. --> Tightening torque: 8 ftlb.
Tightening sequence:
Subsequent work
Topping up ATF
Caution: Oil fill level too low
^
Risk of damage to components
--> Do not start engine.
--> Do not tow the vehicle.
Warning: Danger of scalding and chemical burns from hot ATF
--> Allow ATF to cool down
--> Wear personal protective gear (goggles, gloves)
1. Unscrew the ATF filler plug -2- and fill up with ATF using ATF filling device V.A.G. 1924 00000 until surplus ATF escapes at the hole of the
ATF filler plug.