Cayenne S (9PA) V8-4.5L (2003)
^
The entire threaded parts of the axle must be tightened in vehicle position. Vehicle position means: vehicle standing on the wheels, or the wheel
suspension is being raised with a universal vehicle lift. -Dimension X-, from lower edge of wing to middle of axle 506 mm +10 mm corresponds to
vehicle position.
^
Use an intermediate layer (hard rubber)! Do not damage the brake cover plate.
^
Screws and nuts are Dacromet-coated and must not be greased.
^
Grease axle nut with a little Optimoly TA aluminum paste only at mounting-face ring.
^
Grease the toothing of the drive shaft with aluminum paste Optimoly TA.
^
Drive shafts must not be left hanging from the joint stop! Tie up.
^
Use new screws and fastening nuts.
^
The wheel bearing seat must be free of grease.
^
Use correct tightening torques.
1. Fit the wheel bearing (tools).
^
Check that the bearing seat is clean and the surface is in good order. There must not be scores, grooves or deformations.