Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Headlamp Control Module: Service and Repair
Removing And Installing Control Unit For Gas-Discharge Headlight
Tools
Technical values
Preliminary work
1. Remove main headlight.
Removing control unit for gas discharge lamp
CAUTION:
Risk of irreparable damage to electrical and electronic components. Risk of damage to headlights.
-
Before removing headlight, remove ignition key and switch off the light.
-
Headlights must not be covered, e.g. by wing protector or film, when they are switched on. Risk of damage to headlights due to chaffing
and excessive temperatures.
INFORMATION:
-
The control unit is located underneath the Bi-Xenon headlight.
-
The control unit also has the task of driving the motors for the headlight beam adjustment (HBA) of the Bi-Xenon headlight.
1. Turn the Bi-Xenon headlight over and set it down on a suitable surface.
2. Unscrew the three fastening screws -1- and remove control unit for gas discharge lamp -2- from the Bi-Xenon headlight in -direction of arrow-.
Installing control unit for gas-discharge headlight
INFORMATION: Make sure the connector for the control unit for the gas discharge lamp is perfectly straight when fitting it into the Bi-Xenon
headlight. Do not use force when inserting the connector.