Cayman S (987) F6-3.4L (2008)
1. Raise the vehicle at the prescribed jacking points.
2. Remove rear right wheel.
3. Remove support plate.
4. Unscrew fastening nuts for restraining cables and remove restraining cables from cross member.
5. Retaining device P 9624/1 must then be screwed to cross member, then turn spindle upwards and support engine.
Draining oil for final drive
Dismantling
1. Loosen fastening screws between anti-roll bar and rear axle carrier side panel and fold anti-roll bar forward.
Note:
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).
2. Remove right drive shaft on transmission side. For this purpose, unscrew six hexagon socket screws between the drive shaft and the transmission
flange, respectively. Counter on the brake disc or activate the parking brake to avoid simultaneous turning.
3. Unscrew fastening screws between the transmission support and the transmission.