Cayman S (987) F6-3.4L (2008)
Differential Output Shaft: Service and Repair
Removing and Installing Right Halfshaft Flange
WM 392519 Removing and installing right halfshaft flange
Preliminary work
Preliminary work
1. Raise the vehicle at the prescribed jacking points.
2. Remove support plate.
3. Place oil collection pan under the transmission.
Removing halfshaft flange
Removing halfshaft flange
Note:
Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).
1. Remove right drive shaft on transmission side. To do this, screw in the six Allen screws joining each drive shaft and transmission flange and
tighten screws. Counter at the wheel or activate the parking brake to avoid simultaneous turning.
2. Remove halfshaft flange. To do this, place a suitable support -B- under the halfshaft flange and press the halfshaft flange out of the transmission by
screwing in a screw -A-.
Installing halfshaft flange
Installing halfshaft flange
1. Replace the circlip for the halfshaft flange. To do this, clamp the halfshaft flange in a vice using a screw -B- and press out the circlip with the new
circlip -A-.