Alliance/Encore L4-1721cc 105 CID (1985)
Wide Open Throttle (WOT) Switch: Adjustments
Renix Throttle Body Fuel Injection (TBFI), Late Type System
It is only necessary to adjust the wide open throttle after replacement to establish the initial position of switch.
1.
Remove throttle body assembly.
2.
Loosen two WOT to bracket retaining screws.
3.
Open throttle to wide open position.
4.
Attach alignment gauge J-26701 or equivalent on flat surface of throttle lever.
5.
Rotate degree scale of gauge until 15° mark is aligned with pointer.
6.
Adjust bubble until it is centered.
7.
Rotate degree scale to align 0° with pointer.
8.
Close throttle slightly to center bubble on gauge. Throttle is now at 15° before wide open throttle position.
9.
Position WOT lever on throttle cam so that switch plunger is just closed at 15° before wide open throttle position.
10.
Tighten WOT retaining screws.
11.
Remove gauge.