9-5 (9600) L4-2.3L Turbo (B235) (2001)
/l4-2.3l_turbo_(b235)/Page-1134001.png)
Fuel Injector: Testing and Inspection
Checking injector flow capacity
WARNING
Removal of the fuel pressure regulator involves partial dismantling of the car's fuel system. The following points must therefore be observed in
connection with this work:
-
Work only in a well-ventilated area! if approved equipment for the extraction of fuel vapour is available then make sure it is used.
-
Wear protective gloves! prolonged contact with fuel can cause skin irritation.
-
Keep a class be fire extinguisher close by! be mindful of the danger of sparks caused by short circuits and when connecting and
disconnecting leads in electrical circuits.
-
Smoking is strictly forbidden.
-
Wear protective goggles.
IMPORTANT
Scrupulous cleanliness is of the utmost importance when working on the fuel rail and injectors. Thoroughly clean the injectors, fuel rail and intake
Manifold and blow dry with compressed air.
1. Remove the fuel rail as instructed in steps 1-18 in method description 4.
2. Fit a transparent hose on the nozzle. This hose should be about 40 cm long and have an inside diameter of 15 mm.
