9-7X L6-4.2L (2008)
1. Install the wheel speed sensor ring using the J 45860 (1) and the J 8092 (2).
2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
3. Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2).
4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
5. Install the axle shaft seal using the J 21128.
6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
7. Install the axle shaft. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair).
8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6/9.5 in lD axle) (See: Transmission and
Drivetrain/Differential Assembly/Differential Cover/Service and Repair).
9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement (See: Rear Wheel Speed Sensor Replacement).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
11. Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.0/8.6 Inch Axle) (See: Maintenance/Fluids/Fluid - Differential/Service and
Repair/Removal and Replacement/Rear Drive Axle).
12. Lower the vehicle.
