9-7X L6-4.2L (2008)
Repair/Engine Protection Shield Replacement).
Important: When placing jack onto the oil pan, pay close attention to not damaging the oil level sender.
11. Lower the vehicle and place a floor jack under the oil pan with a block of wood.
12. Raise the engine with the jack just enough to clear the engine mount studs.
13. Remove the right engine mount from the bracket. Note the location of the heat shield for installation.
14. Graphic shows left, right is similar.
Remove the right engine mount bracket bolts (1).
15. Remove the right engine mount bracket.
16. Graphic shows left, right is similar.
Remove the right frame engine mount bracket bolts, if required.
17. Remove the right frame engine mount bracket, if required.
Installation Procedure
1. Graphic shows left, right is similar.
Install the right frame engine mount bracket, if removed.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice).
2. Install the right frame engine mount bracket bolts, if removed.
Tighten the mount bracket bolts to 110 Nm (81 ft. lbs.).