9-7X V8-5.3L (2005)
10. Use the following procedure if the vehicle is equipped with 2WD:
1. Install the EVAP/fuel hose/pipe assembly to the retaining clips (1) on the transmission.
2. Raise the transmission to the normal installed height.
3. Install the transmission support. Refer to Transmission Support Replacement (See: Body and Frame/Frame/Cross-Member/Service and
Repair/Transmission Support Replacement).
4. Remove the transmission jack.
11. Install the nuts securing the right catalytic converter to the exhaust manifold.
Tighten the nuts to 50 Nm (37 ft. lbs.).
