Astra L4-1.8L (2009)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the brake hose to the brake caliper with a banjo bolt and new seal rings.
Tighten the brake hose banjo bolt to 40 Nm (30 lb ft).
Note:
*
If present, install the brake hose for IDS+ chassis. Note the installation dimension (I) of protector (arrow). Installation dimension (I) 53 mm.
*
Ensure that the brake hose is not twisted when installed.
2. Install the brake line to the brake hose.
Tighten the brake line to brake hose to 14 Nm (124 lb in).
3. Insert the brake hose in the bracket and slide on the retaining plate.
4. Install the wheel sensor wiring harness retaining clip (1).
