Astra L4-1.8L (2009)
5. Install the front wheel.
Tighten the front wheel bolts to 110 Nm (81 lb ft).
6. Bleed the brake system and check for leaks. Refer to Hydraulic Brake System Bleeding (See: Brake Bleeding/Service and Repair).
7. Top up the brake fluid level so that it reaches the mark MAX. Refer to Master Cylinder Reservoir Filling (See: Brake Master Cylinder/Service
and Repair/Procedures).
Rear Brake Hose Replacement
Rear Brake Hose Replacement
Removal Procedure
1. Top up the brake fluid reservoir to the MAX marking and seal.
2. Remove the rear wheel.
Note: Collect the escaping brake fluid and seal the apertures.
3. Remove the brake line connection (2) from the brake hose on vehicle underbody.
4. Unscrew the banjo bolt (1) from the brake caliper.
5. Remove the brake hose from the mounting.
*
Remove the mounting (3) from the rear axle.
*
Remove the bolt.
Installation Procedure
1. Insert the brake hose in mounting.
*
Install the mounting to the rear axle.
*
Install the bolt.
