Astra L4-1.8L (2009)
3. Make alignment mark on the toothed belt drive belt.
4. Turn the crankshaft to ignition TDC marking, cylinder number 1.
5. Block the crankshaft.
Attach KM-6625 .
*
Detach the screwed connection (1).
*
Insert KM-6625 (2).
*
Tighten the screwed connection (3).
6. Lower the vehicle by its full height.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the supports (1).
*
Adjust the MKM-6086-6 supports.
Adjust the support heads so that they are centered in respect of the support feet (3) and tighten.
*
Push the MKM-6086-3 installation shaft (2) into the supports.
*
Place both supports with installation shaft onto the cylinders 2 and 3, align in the center over the spark plug bores and bolt on.
*
Tighten the 4 bolts.
*
Secure installation shaft.
*
Tighten the 2 bolts.
8. Attach the MKM-6086-15 pneumatic adapter (1).
*
Attach the adapter to cylinder number 1.
*
Apply compressed air to cylinder number 1.
