saturn Workshop Repair Guides

Saturn Workshop Service and Repair Manuals

Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10137 > < Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10135
Page 14
background image

Note:  With already replaced roof side rail modules, do not bend the clamps on positions 3 and 4.

2. Remove the roof side rail modules.

*

Release and disconnect the wiring harness plug.

*

Remove the 2 bolts (1).

*

Remove the 6 screws (2).

Installation Procedure

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

1. Install the roof side rail modules.

Connect and latch the wiring harness plug.

Tighten the 8 screws to 1.5 Nm (13 lb in).

2. Install the headlining trim panel. Refer to Headlining Trim Panel Replacement (Sedan)   (See: Body and Frame/Interior Moulding /

Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (With Sunroof)   (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)Headlining Trim Panel Replacement (Coupe)   (See: Body and Frame/Interior Moulding /
Trim/Headliner/Service and Repair)

Note:  After ignition ON, the roof side rail module system readiness indicator illuminates for 4 seconds and then goes out.

Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10137 > < Driver or Passenger Seat Side Inflatable Restraint Module Replacement|Page 10135