Astra L4-1.8L (2009)
9. Side airbag sensor, replace.
*
Remove the 2 bolts.
*
Release and disconnect the wiring harness plug.
*
Remove the side airbag sensor.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the side airbag sensor.
*
Insert the side airbag sensor.
Tighten the 2 bolts to 6 Nm (53 lb in).
*
Connect and latch the wiring harness plug.
2. Install the rear quarter panel front inner paneling.
*
Install the 8 front quarter panel clips.
-
Tighten the bolt on the upper center pillar to 2.5 Nm (22 lb in).
-
Tighten the bolt to the rear seat backrest to 25 Nm (18 lb ft).
-
Tighten the bolt on lower center pillar to 2.5 Nm (22 lb in).
*
Install the rear quarter panel cover cap front.
*
Install the belt striker guide bushing to the rear quarter panel front.
*
Install the belt with the striker.
*
Install the lower belt striker.
Tighten the lower belt fastening bolt to 25 Nm (18 lb ft).
3. Install the sill inner paneling.
Install the 5 clips.
4. Insert the rear seat backrest.
5. Install the rear seat backrest.
*
Guide in and position the rear seat backrest with the guide pins right and left in the rear quarter panel.
Tighten the 4 rear bolts to 35 Nm (25 lb ft).
