ION L4-2.2L VIN F (2004)
1. Install the brake pedal assembly to the vehicle.
2. Install the cruise control release switch, if equipped, to the pedal bracket.
3. Install the stop lamp switch to the pedal bracket.
4. Move the brake pedal assembly to the installed position.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the brake pedal bracket-to-steering column bracket bolt (1).
-
Tighten the bolt to 25 Nm (18 ft. lbs.).
6. Loosely install the brake booster mounting nuts.
7. Apply a thin coating of lithium grease to the pushrod pin on the brake pedal.
8. Connect the brake booster pushrod (2) to the brake pedal.
9. Install the washer (3) and retaining clip (4) to the brake pedal.
10. Tighten the vacuum brake booster mounting nuts.
-
Tighten the nuts to 25 Nm (18 ft. lbs.).
11. Install the accelerator pedal into position and install the pedal mounting nuts.
12. Adjust the stop lamp switch.
13. Adjust the cruise control release switch, if equipped.
14. Install the cruise control module, if equipped, to the brake pedal bracket.
15. Secure the EPS wiring harness to the pedal bracket.
