ION L4-2.2L VIN F (2004)
1. Install the rear transaxle mount to transaxle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Using the following sequence, install the rear transaxle mount bracket bolts:
2.1.
Tighten the middle bolt to 60 Nm (44 ft. lbs.).
2.2.
Tighten the lower bolt to 60 Nm (44 ft. lbs.).
2.3.
Tighten the upper bolt to 60 Nm (44 ft. lbs.).
3. Install the axle boot heat shield.
4. Install the axle boot heat shield bolts.
^
Tighten the heat shield to transmission mount bracket bolt to 10 Nm (89 inch lbs.).
^
Tighten the heat shield to engine bolt to 30 Nm (22 ft. lbs.).
5. Install the rear transaxle mount.
