L300 V6-3.0L VIN R (2001)
result.
3. Use a wrench on inner tie rod flats to turn inner tie rods in direction of desired change.
4. After toe adjustment is complete, tighten left side and right side inner tie rod-to-outer tie rod jam nuts.
Torque: Inner Tie Rod-to-Outer Tie Rod Jam Nuts: 60 Nm (44 ft. lbs.)
5. Re-check toe angles to ensure proper adjustment and re-adjust if necessary.
Rear Wheel Alignment
REAR WHEEL ALIGNMENT
Rear wheel alignment involves setting the toe angle. Rear wheel camber is not adjustable.
IMPORTANT: Rear wheel alignment angles must be set to correct specifications before front wheel alignment angles are adjusted.
REAR WHEEL TOE
-
TOOLS REQUIRED
-
KM-900 Rear Toe Adjusting Too]
-
SA9140E Torque Angle Gauge
1. Remove rear axle control arm bolts and cage nuts and discard.
NOTICE: Use new bolts and cage nuts. Torque retention of old bolts and nuts may not be sufficient.
IMPORTANT: Do not tighten bolts at this time.
2. Install new bolts leaving the inside forward bolt out.
3. Install Rear Toe Adjusting Tool KM-900, into the open bolt hole.
