L300 V6-3.0L VIN R (2001)
7. Loosen pinch bolt securing control assembly rod to control shaft lever assembly.
NOTICE: The control shaft lever retaining pin has a spring loaded locking feature securing pin in place. If this spring is not depressed before
attempting to remove the pin, damage to pin will result.
8. Remove pin retaining control shaft lever to shift control shaft of transaxle.
9. Remove retaining clips holding control shaft lever assembly to transaxle and frame assembly brackets.
10. Remove control shaft lever assembly by pulling straight up off of pivot pins.
INSTALLATION
IMPORTANT: When installing control shaft lever assembly, guide shifter rod and transaxle shift fork block in place before installing retaining clips.
