L Series V6-3.0L VIN R (2004)
8. Remove the right side front splash shield pushpins and screws to remove the splash shield.
9. Remove the belt tensioner bolts and remove the belt tensioner.
10. Remove the generator L-terminal connector nut (ring terminal nut), then remove the connector from the generator.
11. Remove the generator charging terminal wire (ORN wire).
12. Remove the lower generator to the engine block bolt and move the generator enough to access the knock sensor 1 wire.
IMPORTANT: Note the knock sensor 1 wire routing before removing the sensor.
13. Remove the knock sensor 1 bolt and the knock sensor 1 from the attachment clips, and then remove the knock sensor 1.
INSTALLATION PROCEDURE
