LW2 V6-3.0L VIN R (2000)
22.
Install lever control switch by fitting into bottom locating holes on ignition module.
23.
Connect connectors to lever control switch. Install connector position assurance (CPA) retainers.
24.
Connect ignition switch electrical connector at right steering column support bracket bolt.
25.
Pull hood release handle forward. Feed cable under hood release handle and slide pin in. Connect cable to filler panel.
26.
Install steering column filler panel and data link connector.
27.
Install and torque screws.
Torque:
Steering Column Filler Panel Fasteners: 2.2 Nm (19 in-lbs)
28.
Install SIR Coil assembly. Refer to "Roll Connector Assembly" installation procedure in the 2000/2001 S-Series Restraints Service Manual.
29.
Enable SIR system. Refer to "Enabling Frontal Inflators" procedure in the 2000/2001 S-Series Body Electrical Volume II Service Manual.
30.
Rotate the ignition cylinder back to the ACC position.
