LW200 L4-2.2L VIN F (2003)
12.
Remove three wiper motor fasteners and remove wiper motor from linkage.
13.
Install new wiper motor on linkage and install fasteners.
Torque
Wiper Motor-to-Frame Fasteners: 5 Nm (44 in-lbs)
Important
Steps 14-16 are required to ensure the wiper motor and crank arm are properly timed to the linkage.
14.
Connect the wiper motor into the vehicle wiper electrical harness.
15.
With the key on, cycle the wiper switch to the "Low Speed" position, and then back to "Park." This will ensure the wiper motor is in the "Park"
position before installing the wiper motor crank arm.
16.
Install wiper motor crank arm, aligning it in between the alignment marks on the linkage mounting plate.
17.
Install crank arm and new washer and nut (a new washer and nut are provided with the replacement motor).
Torque
Wiper Mount Crank Arm Nut: 15-20 Nm (11-15 ft-lbs)
18.
Install linkage connecting wiper arm to wiper motor crank arm ball stud.
INSTALLATION
1.
Install wiper motor/linkage to plenum area.
2.
Install wiper linkage retaining bolts.
