Sedan L4-1.9L DOHC VIN 7 (1994)
^
Locator Pin (2)
REMOVAL
Important
Removing the seat using the following sequence will aid in reassembly of the unit. On Coupe passenger seat, DO NOT activate the E-Z entry
feature by pulling the recliner release lever on the side of the seat at any time during removal and installation procedures.
1.
Remove the seat belt from seat belt guide on seat.
2.
Move seat to full rearward position by activating the seat adjuster lever.
3.
Remove the two front bolts from seat in the following order:
A.
Front inboard
B.
Front outboard
4.
Move seat to full forward position by activating the seat adjuster lever.
5.
Remove the two rear bolts from front seat in the following order:
A.
Rear outboard
B.
Rear inboard
6.
For driver's seat, tilt seat backwards and disconnect seat side mount buckle unit wiring harness.
7.
Remove seat and place on a clean, protected work surface.
8.
On SL2, SC2, and SW2 driver's seat, rotate riser knob to full down position, and remove riser knob cover, fastener, and riser knob.
9.
Remove recliner handle fastener and recliner handle.
10.
Remove two outboard seat adjuster side cover fasteners and cover.
11.
Remove two inboard seat adjuster side cover fasteners and cover.
