Sky L4-2.0L Turbo (2008)
4. Install a 30-amp fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for
less than 2 ohms between terminals 30 and 87.
‹› If greater than the specified range, replace the relay.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay
Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power
Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))
*
Horn Replacement (See: Service and Repair)
*
Inflatable Restraint Steering Wheel Module Replacement (See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair)
*
Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming
