SL L4-1.9L SOHC VIN 8 (1997)
1. Position the engine bracket to the engine and install the four engine bracket-to-engine fasteners.
-
Torque: 70 Nm (52 ft. lbs.)
2. Install the strut-to-cradle bracket and the engine bracket fasteners.
-
Torque: 70 Nm (52 ft. lbs.)
3. Loosen the two engine strut bracket-to-cradle fasteners to remove any fore/aft preload from the engine strut.
4. Tighten the engine strut bracket-to-cradle fasteners.
-
Torque: 50 Nm (37 ft. lbs.)
5. Install the right side splash shield.
IMPORTANT: Install front section of shield first, then rear.
6. Install tabs in body cut-out.
7. Align molded-in shield fasteners with holes in cradle. Push straight in to install.
8. Install push pins.