SL L4-1.9L SOHC VIN 8 (1997)
9. Install belt tensioner.
^
Torque: 30 Nm (22 ft. lbs.)
10. Install the accessory drive belt idler pulley.
^
Torque: 27 Nm (20 ft. lbs.)
11. Drain engine oil and change filter. Install drain plug.
^
Torque: 35 Nm (26 ft. lbs.)
12. Verify gap on all spark plugs.
a. Install spark plugs.
^
Torque: 27 Nm (20 ft. lbs.)
13. Install accelerator linkage bracket and attach throttle cable. Make sure the throttle cable is properly routed and not binding.
^
Torque: 25 Nm (19 ft. lbs.)
14. Install the following sensors and components:
a. Generator attachment bolts, if removed.
^
Torque: 32 Nm (24 ft. lbs.)
b. Starter motor to block, if removed.
^
Torque: 37 Nm (27 ft. lbs.)
c. Starter support bracket to axle shaft bracket, if removed.
^
Torque: 30 Nm (22 ft. lbs.)
15. Install power steering pump assembly.
^
Torque: 30 Nm (22 ft. lbs.)
16. A/C compressor/brackets.
^
Rear bracket to block and compressor:
Torque: 25 Nm (19 ft. lbs.)
^
Front bracket to block and compressor:
Torque: 47 Nm (35 ft. lbs.)
17. Install accessory drive belt. Make sure the belt is properly aligned on the pulleys.
NOTICE: To prevent engine front cover and mount damage, the three front upper mount to engine front cover nuts must be tightened down
uniformly.