SL L4-1.9L SOHC VIN 8 (1997)
18. Install the two mount to midrail bracket nuts first. Next, install the three front upper mount to engine front cover nuts. Remove the block of wood
from under the torque strut after the upper mount assembly is installed.
Upper Mount to Front Cover:
^
Torque: 50 Nm (37 ft. lbs.)
Upper Mount to Frame Rail Bracket:
^
Torque: 50 Nm (37 ft. lbs.)
19. Install the splash shield and wheel.
^
Torque: 140 Nm (103 ft. lbs.)
20. Connect the following hoses:
^
EVAP cannister purge
^
Throttle body vacuum harness
^
PCV
^
Fresh air
^
Brake booster
^
MAP sensor
^
Upper radiator hose
^
Heater hose
21. Install electrical sensors and harness connectors:
^
Grounds (if disconnected) at engine/transaxle 25
^
Torque: 25Nm (19 ft. lbs.)
^
Oxygen sensor
^
Torque: 25 Nm (19 ft. lbs.)
^
Coolant temperature (two separate sensors)
^
Torque: 8 Nm (71 in. lbs.)
^
Fuel injectors
^
Idle air control (IAC)
^
EGR valve
^
Torque: 25 Nm (19 ft. lbs.)
^
Throttle position (TP) sensor
^
EVAP Canister Purge
^
Manifold air pressure (MAP)
^
Generator
^
Starter Motor
^
A/C Compressor
22. Install intake manifold support bracket: