SW L4-1.9L DOHC VIN 7 (1993)
IMPORTANT:
To assist in loosening nozzle, pry between plastic at base of nozzle hose connector and wiper motor linkage.
5.
Remove nozzle from end of rear wiper module pivot shaft with pliers and discard nozzle.
6.
Remove nozzle hose connector from pivot shaft by disengaging tab from wiper base plate.
7.
Disconnect washer fluid hose retaining tab.
8.
Disconnect washer fluid hose from supply hose.
9.
Lubricate outside portion of new nozzle hose connector that goes inside pivot shaft with lubricant (P/N 21038914).
10.
Install nozzle hose connector into rear wiper module pivot shaft until tab on nozzle hose connector is engaged into wiper base plate.
IMPORTANT:
If nozzle opening is not installed in 12 o'clock position, it will not seat correctly.
11.
Place new nozzle into threaded end of pivot shaft so nozzle opening is in 12 o'clock position as installed in vehicle.
12.
To seat nozzle in nozzle hose connector, apply pressure to top of nozzle and end of nozzle hose connector at base of rear wiper module pivot shaft.
Nozzle should snap in place and not be able to be pulled back out easily.
13.
Connect washer fluid hose to nozzle hose connector and supply line.
14.
Insert washer fluid hose retaining tab into washer module base plate.
15.
Install lower trim panel by aligning and pushing at upper clips into their locations.
16.
Reset trim panel push in fasteners by spreading center pin tabs and moving center pin so that it extends out approximately 6 mm (1/4 in.).
