SW2 L4-1.9L DOHC VIN 7 (1997)
Radio/Stereo: Service and Repair
Installation
Radio Installation
1. Connect electrical connector and antenna to radio.
Radio Installation
2. Install radio.
Important: Make sure spring clips are seated in D-holes on both sides.
3. Install and tighten screws.
Torque: 2.5 N-m (22 in-lbs)
Radio Installation
4. Connect traction control/fog lamp/rear defog electrical connector, if equipped.
5. Install radio/HVAC control cover. Push in at clip locations.
6. Install push pins and lock.
